Bedliner DTM 13L No Primer Schutz kit

Bedliner DTM 13L No Primer Schutz kit

This kit is an anti-corrosiive tough paint, to be applied with the gun provided giving you a heavy resilient bedliner texture easy to apply.

DTM is suitable for Vehicle Ramps, Textured body resprays, use as a bedliner, a heavy duty coating, or a chassis paint. 

• High Adhesion. Designed for mechanically prepared surfaces.
• Texture can be varied using adjustable nozzle, our 1K thinner, and spraying techniques.
• Impregnated with toughened glass flake for increased hardness, abrasion, and porosity resistance.
• Cost effective. No requirement for a primer or top coat.
• Long lasting. Suitable for Marine, Industrial and other aggressive environments.
• Easy to clean / maintain. low gloss/ high satin sheen.
• HIGH SOLIDS 52%.
• No thinner required reducing complication and increasing savings.
• Great UV resistance.

Colours

• Simply enter your colour preference and we will make this ready for you to simply shake, decant and spray. No hardners, colour mixing, ratio's or isoocyanates. 

Suitability

Compatible with most fully cured paint systems, DTM is suitable for protecting a range of prepared steel surfaces from chassis and underbody to axles, bodywork and more.

DO I WANT THE PRIMER UPGRADE?

DTM DOES NOT require a primer. HOWEVER> if you want to stabilise some rust, ensure that rust cannot creep below the paint, are doing a bare metal sprayjob, or want to improve the level of protection, have different coloured panels etc, then 10L of RE will stabilise, seal, promote adhesion, and improve the overall job. Its a VERY tough primer that can go direct to prepared rust. 

Preparation

1. Ensure surfaces are, dry, clean and free from grease, dirt and other contamination.
2. Remove scale and rust and prepare to a minimum ST3.
3. Apply two coats by applying initially 100 micron wet followed by a brief dry off period then a further application of up to 200 micron.
4. Allow to dry for approx. 3 hours before handling

Application Methods.

Aerosol > typically 4 coats.  Check film is minimum 100 microns DFT, > 180 microns for higher profile such as aggressive blasting.

Schultz tin spray- Applied neat 60> 75PSI typically

• FX11 Underbody Gun 75 PSI MAX, nozzle fully out. start around 40psi

Properties

Satin / matt depending on temperatures applied at (higher temps, and thicker coating gives more of a sheen).

This kit will cover a smaller vehicle. Purchase more DTM here

Pro's

Cost effective protection of steel surfaces

Variety of colours and application methods available.

Con's

Corrosion needs to be remedied prior to application.

Quantities estimate

Large 4x4 chassis (110 size) 5L or 24 cans

Winch Bumper 1L

Axle 1L

Nas Step 1L

Half Chassis/ small 4x4 2.5L

Small vehicle underbody 2.5L

Large 4x4 underbody 5L

Bedliner DTM  1K 5L No Primer Schutz kit