Splash Waxoil / Undersealing rust penetrant stabiliser 1000ml
Splash serves a muiltitude of purposes, increasing longevity of a treatment, reducing failuires, and making the process faster.
Splash is applied directly to corrosion like a rust covnerter, but is faster as its spray on. It will also work on bare steel and existing paints. Once applied Splash will push off any moisture and air within the corrosion, cancelling the corrosion cells that create more rust. Due to this extreme effect, even when applied to wet rust directly after washign, Splash helps dry a wet chassis, seal it, and prepare it for a top coat.
Splash is ideal to be top coated with all traditional lanolin oils and waxes, as well as wax and bitumous based coatings.
Splash penetrates corrosion, where a rust converter cannot due to its chemical makeup, therefore will out perform most converters in most scenarios.
1L is enough to treat msot vehciles and 4x4's
Product Pro's
- Dewatering action. Splash will actively remove and push moisture out of exisitng corrosion, and more.
- Cheap! we aim to make this product as cheap as we possibly can whilst fulfilling the product criteria.
- Anti- corrosive. Whilst Splash doesnt have the longevity of chassis guard by itself it acts as the PERFECT primer for it.
- High penetration into existing corrosion- Even higher than Chassis guard! Splash will offer some benefit even on dry corrosion.
- Hydrophobic to shed water and minimise latent moisture build up. NOT STICKY!
- Easy to remove
- Non Toxic
- Fully Biodegradeable (packaging will not initially meet this criteria whilst we work on the core product (bottles are now PCR)
- Ultra Low VOC.
- Clear so you visually inspect the substrate
- Superbv as a short term protection by itself 1>2 months typical.
- Great as a cavity treatment with great rust penetration and creep, topup with chassis guard after.
- Drives heavy corrosion from the base steel over time
Cons
- Clear- we have no plans or intention to release a coloured version. This product is aimed squarely at low cost protection vs time. Nothing else.
- You dont have to use this product. Chassis Guard does not require a primer, but Splash is required for best effectiveness on damp corrosion.
Useage
- Remove any mud
- Heavier corrosion can be removed to increase product penetration, or can be left and topped up later on be aware that large lumps of rust (delamination) can come off and not be fully penetrated. If you treat a vehicle with lumps of rust, ensure you inspect and topup more often whilst the corrosion is driven off the base metal by Chassis Guard over time.
- Apply liberally to damp / wet areas. Splash will drive off the moisture in beads until it cures full dry. You can then top coat with chassis guard as per normal.
We generally recommend 1:2 ratio of splash. 1 Splashy, for two chassis guard. This is becuase splash covers a little better and you dont tend to need it everywhere. 1:1 is fine if you want to be as thorough as possible.
FAQ
Will Splash work with Lanoguard and other, lanolin coatings?
Yes, Splash will work as a stabiliser / undercoat for most oil, Lanolin, Wax & Bitumous coatings.
Can i use Splash with Zero Prep?
Zero Prep (UP) has its own dewatering action built in. SO there is no need to use this coating there.
